|
kc,
You delaminated totally differently than I did. I avoid localized heating which I feared might cause local stress in the glass, a big no-no. I thought of a hot wire and also a rope saw but did not go those routes for the heat buildup concern.
In other electronics work I have used a clear silicone potting compound which pours like thin syrup and is a two part that cures like epoxy, used for potting electronic modules from Dow Corning. Is this the stuff you used?
In my 21FJP22 rebuild I left a ~0.100 inch air gap filled with dry argon and merely sealed the faceplate onto the CRT with a bead of RTV around the periphery to seal it up. Faceplate can be removed fairly easily with a razor knife to save it if desired (groovy large glass dish) when the CRT is finally toast.
Rob
Last edited by Rob; 12-02-2002 at 02:46 AM.
|