|
roger that Charlie.
the only other thing is I did swap the two vert out transformer wires on pin 4 and 5 on the convergence socket. This was against the color code but the color code for the thordarson was not given (all the other replacement trannys were, and they all used the same color red for red, red blk for red blk etc...). When I installed the thordarson I 1st check the resistance of the old tranny to the wires of the replacement. They all checked for resistance for the same colors except for those two which were swapped. So I installed it with the wiring intact except those two.
I was thinking of swapping them just to see. I think the diff was .75 ohms to center vs 1.5 ohms to center which is a pretty big diff in DC resistance in a tranny.
I don't want to do too many changes at a time so I will try the magnet 1st
then the diodes, then the wire swap.
on the grid its all pretty good but the blue is about 3/8 in off on the horz line on the bottom all the way across, and that is with the pot pegged (its working just not enough range).
|