|
I still have not tried the purity setup, I know that is suppose to be the 1st thing, guess I am just a bit nervous about pulling back the yoke.
I am still wondering if those diodes could be part of the issue. I have not studied the schematic, but if they are there to rectify the currend from the secondary of the vert output, and if they are weak, then maybe the magnetic field is not as strong as it should be. Again just guessing I reall dont have a clue as to what is going on in the convergence circuit.
Also have a real tough time with linearity, both vert and horz are way off.
I did not see a horz linearity adj, so figured I would start with checking the horz osc/damper/HOT for starters.
The vert is tough also cant get it to fill out the screen unless I mis adjust the vert linearity. I think maybe its a vert centering adj that needs to be done, to bring it all down 1st. Need to look over the set instructions again.
|