[DaveWM]

here are some ideas for the cabinet design,

4 side ply box with some oak veneers.

simple splayed legs with a front and rear stretcher, set in a bit, all splays about 15 degrees, all exposed edged rounded over. legs from hardwood, all finished with tung oil.

I will do some full size mockups out out foam to see how the legs work out.

Lacking a table saw will mean some creative jigging for my circlular saw, but the veneers should cover any minor mistakes.

I would not mind getting a router to do the bulk of the rounding over of the legs but then again I could prob do it with hand tools and patience.

pls excuse the rough drawing, just try for the right look.