Thread: Zenith CC II 19JC55Z tint and other issues
View Single Post
  #10  
Old 12-13-2009, 07:18 PM
TinCanAlley's Avatar
TinCanAlley TinCanAlley is offline
VideoKarma Member
  
Join Date: Sep 2008
Location: So Cal, CA
Posts: 937
Well I pulled the boards and check all the solder points. Seems for the past 32 years the luma module's resistor pack had the end three legs not soldered. Under close inspection, the end three showed no solder and light coming through around the legs on the back side of the board. I soldered them and cleaned all the contacts on all the boards with Deoxit.

So far, so good! No changes in tint and the contrast doesn't drop when tapping on the set.

Thanks for all the assistance and look for my new post on another issue.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL

Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
Reply With Quote
Audiokarma