[bandersen]

Originally Posted by leadlike

I've always redone the wiring on Philco speaker harnesses-they just don't seem to hold up that well. I have a roll of cloth-covered brown wire for just such a purpose. As far as the tacked-on repairs go, that is how they all seem to have been done. I know Philco had radio-counter displays so you could grab the replacement bakelite block you needed, but they apparently never sold many of them.

I restuff bakelite blocks, but I don't use the heat gun/oven methods, I just pull the block, and chisel out the guts with a small screwdriver. It takes about two minutes to get them all cleaned out. One of the blocks in my 60 had two mica caps in it, so I just let it be, since the other micas in the set tested fine.

I have some three-conductor cloth covered repro. wiring around here somewhere too. The guts are popping out of a couple of these already so I'll try your technique. Hot stinky tar isn't much fun

There's also a 5-section cap in a metal box. I hope that won't be a pain to restuff.
I hope I won't need to do an alignment.
I'm amazed at how many trimmer caps there are. Something like 7 in total.

Originally Posted by Reece

I'm always harping on this, but I would put a plywood bottom shelf under that speaker all the way to the back of the cabinet to enclose the bottom of the speaker compartment. The way they made them there's an acoustic short circuit from the front to the back of the cone: result, less bass.

Thanks for the suggestion. Once I get it working, I'll do a comparison with and without a bottom shelf.