[Charlie]

My new orange drops came in the mail today. They've all been changed except in the color section. All I can say at this point is I have a really good raster. No signal, still. Kinda disappointing. I might break out my B&K Analyst and see if I can figure out where the problem is.

When I got my HV probe out, I was "shocked" to see that a had 30KV!! Holy high voltage, Batman! This was discovered before changing out caps. I found the HV adjust was turned all the way to the stop. When I backed it off, I was able to get it down to 25KV... which is still a little too high. I haven't noticed the HV shutting down like I did the other day... but then I haven't let the set run too long at once so far since I haven't checked the HO current yet. Just for giggles, I changed the HO tube because it looked like it had been road hard and hung dry.