Quote:
Originally Posted by DaveWM
did you check the screen voltage of the HOT? If you have a good drive signal I would start by subbing in a new HOT/Damper as well. Is the Damper filament staying lit the whole time, I had a bad ground stake that would cause it to go out.
|
Hi Dave,
I've subbed a new 6DA4 damper, and I've also replaced the sockets of both the HOR out and the Damper tubes. All of the filaments stay lit, but I haven't checked the screen voltage of the HOT. (Just so I know, are you talking
HOR
out
tube, or
HOR
out
transformer?)
I'm assuming you mean the 6DQ6 o/p tube.
Cheers,
Adam