|
well a .01 was replaced by a .0033, but I think its just part of the integrater, C506, so I don't think it would effect the timing of the osc, but I am not sure about that. I will put the correct cap in anyway. I confirmed the .01 by checking another chassis and indeed it was a .01.
Next up I will need to check the 6.8meg 5% resistor that goes to the vert hold pot, and then finally the 820k from the screen of the vert out to the pot, seems to form a voltage divider from the 300v to ground thru the vert hold pot. will also look at the 39k resistor in the feed back circuit and a couple others there as well.
|