|
the can is a multi section cap with a common ground. IF the can connected to the chassis then you would connect the neg lead of the 50u cap to ANY place on the chassis. IF the can was not grounded then you would connect the neg lead to the can itself. In this case IF you are looking at the right can (C104) and the right section (B) then you would disconnect any thing connected to the "B" section and and then connect those wires resistors what ever you just disconnected to a pos lead of a 50uf and the neg lead of said 50uf to what ever the can was connected to, IF you are on the right can it would be the chassis.
maybe you should take a hi res pic of what you are doing.
|