[timmy]

Well ok what I wrote above was off a bit, what happened is I put the set on and the sound and picture was a bit fuzzy and after a few seconds both cleared up so I turned it off and Alittle later put it on and there was no sound or picture then I had done what I had wrote in the last post. Shorting out the neg tube came after because I was in doubt about the caps that were in the set to begin wth so I parallel one and messed up. But the sound and pic just went out and I subbed all Micas in that circuit as well as tubes and found one resistor and replaced it so it seems as if the IF is simply dead and can't find out why. Even tried another source for video and no good. Any help would be greatly appreciated!!! Is there another part of a black and white chassis that would prevent the IF from working ?