Now the other Zenith is 95% finished and working, I've decided to start back on this one again. The issue I'm having with this one is the horizontal starts to shrink after running for around half an hour, all the electrolytic's have been replaced and the paper and black beauty caps have been as well it's pretty much fully recaped, works great with the typical sharp Zenith picture for around a half an hour although I did notice there is a waveeness to the picture, I've also lost vertical once but have not had any problems ever sense with that, whatever component it is that is causing this does not like heat, as I put a small PC fan underneath the chassis and it ran fine for 2 hours but obviously that's not a permanent fix though
I also noticed the power transformer seems to be running very hot to the point where you can't really touch it very long if at all. I tried freeze spray on the resistors and pretty much everything underneath the chassis as I can run this set upside down being the CRT is attached to the chassis and nothing changed, I've also tested resistors and changed tubes even though they tested good and that didn't seem to do anything neither. The set originally had a shorted electrolytic that I replaced and it brought this set back to life and I ended up replacing all the electrolytic's. I really don't know where to go from here my troubleshooting skills are limited, and the only real piece of test equipment I have is my multi meter and variac if you guys have any ideas about this issue let me know. Thanks again