Ok, all the hv caps are new and still don't have verticle this set is beginning to remind me of the silvertone. Any ideas what may be going on here. It's like it's rolling so much the screen just collapsed. There are 2 caps at the 6sl7, a 100 mmf and a 250 mmf I subbed those as well even tried another .004 cap at the 6sl7 also checked both vert size and hold pots both good 5 meg . There are no resistors that are bad I went over them clipping one leg to be sure. The 6.8 Meg's at the 6sl7 are up Alittle 7.5 meg which my other sets were up around there as well. All the 2.2 meg resistors are good except one I changed. Tried other tubes no change. The b+ and b++ voltages are right on. All Micas in the verticle and horiz I changed one at a time to see if there was any difference from mica to mica still no change. So now I guess I'm looking for one of the pros here to tell me what I may or may not have done. When I first fired the set up for the first time it had vert hold but the pot was maxed to keep it from rolling I then turned it off for some reason or other came back to it and had this crazy verticle problem.