[trinescope]

Well I have results and some more problems to overcome. I can get picture and sound. I have no color sync at this point. I need to repair the broken coil plug on the hue control and see if that helps. It seems to have normal signal flow in the chroma section when checking with a scope, it just won't sync up. I can get on both sides of the lock point with the color hold control, so that is likely OK.

Next is the HV supply. I was able to repair the damaged focus pot. I made a new resistance track using thin phenolic board and pencil lead. I applied the pencil lead to the roughed up surface of the phenolic strip until I got the correct resistance value. I then installed it in the potentiometer housing. It seems to hold up even when constantly adjusting the control. I had to replace two doorknob capacitors as well. Now I get 27KV and can't regulate it down to normal. Possibly one of the high value resistors is out of tolerance.

Last on the list is the vertical convergence transformer. The reproduction parts are no longer available so I will have to rewind it myself at some point. For now I have wired around it for testing. Of course the convergence is off, but at least I can see how the rest of the set is working.

The CRT may be weak or the kind of picture I'm getting is a result of the excessive HV. It's better than a completely dud tube at least.