Quote:
Originally Posted by Yamamaya42
it was removed, to make room for the larger CRT, the bezel covers that up
if you look at this low-rez pic here, you can see where the hole would have been for it,,
https://imgur.com/LO6LqLa
so I can leave the 1 m resistor and .01 cap off of that vol cont ( center tap) and it wont matter? :O |
It will have a tonal effect at lower volumes.
IMO not a deal breaker, at least not when you can replace it with a taped control at any point down the road. If anything it will be very brilliant sounding in the mid range, compared to loudness compensated. If this were my set I'd be focusing on getting it minimally effort operational and tweak the little things after you come up with a completion game plan. Also there's a good reason why the manufacture kept all the audio tubes and volume control in that very confined area.
