|
alignment question...
In the sams, it says that if you are doing an IF alignment with CRT removed, to remove V22( horz osc ) to disable HV, but in the many videos I have seen, (mostly shango066 stuff ) , that this is bad, as it can cause the HOT to over bias and melt down w/o being fed an osc source.
this chassis has S2 ( fuse 2) which is easy access under side, that cuts power from the damper cathode to the FBT primary, would not pulling that be a safer easier way to disable HV than to remove the horz osc tube?
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
|