|
Ok got an update the 6gk6 pin 1 150 ohm resistor to ground burned up changed the resistor and that one started getting real hot so I pulled the tube and put the old one tube in and it didn’t get hot again but at the same time the old tube shows very little emission on the tester so this resistor may not be getting hot because the tube is bearly conducting. So I have to wonder why this is happening with a new tube either the tube is defective or something else is being affected in the audio circuit. And with the old tube in all the voltages came back to normal so this was the problem area. So what possibly could cause this when the tube conducts.
|