[timmy]

Originally Posted by Yamamaya42

If you have replaced them already, you have virtually nothing to gain by replacing them again at this point, the problem is someplace else.

C3A, C2B, C3B, C2C,
https://www.mouser.com/ProductDetail...nVkrybSw%3D%3D

https://www.mouser.com/ProductDetail...j1prphYw%3D%3D

https://www.mouser.com/ProductDetail...K8MOO7xA%3D%3D

prob replacements.

“low esr” caps are really not the right kind for this area, and hard to find in the values needed, General Purpose Electrolytic Capacitors will do just fine here.

ok I thought low esr caps were better I can’t imagine where this pull is coming from what is it in this set that’s going to pull 3 voltages down I did nothing to this chassis to suggest a major mistake and I can bet it’s the horizontal oscillator alone pulling everything down while still having hv even though it’s low.