|
Definitely in the The Twilight Zone with the development, if what he is reading is correct.
The only thing I can picture happening is, A17 was acting up from the start, and the cause of the old crystal to not work, or, something went VERY wrong when it was adjusted for maximum reading, like the entire coil turned, and tore wires perhaps?
Timmy's last voltage check of pin 6 V23 (PLATE) was at 189v, should be 220v, a tad low, from a 275v source, via a 8.2k resistor and through the 5.2 ohm coil, I would suspect if the coil was open when this was taken, it would be much lower than 189v? :O
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
|