Quote:
Originally Posted by Yamamaya42
The only thing I can think of, is out of tol resistors in the sync area, especially near the 6AL5 phase det, when I restored my FADA 630TS clone, many resistors were replaced, if perhaps the 2 470k resistors and the 1m are a bit off, it might upset the horz phasing, I'm sure they were replaced with 1% new in my set, as well as most of the other resistors in the sync area that did not test within 10% what they should have.
|
The two 470K and 1M resistors have been replaced with 1% resistors. All the resistors around the 6AL5, except for the 5K power resistor that tests spot on, have been replaced