|
The yoke back cover is easy...ACE hardware sells a whitish and translucent 1gal paint can plastic snap cover (it's bigger around than the factory lids on the can as it's meant to wrap over the outside of sides of the can)...For RCA 21CT55s, CTC-4 s CTC-5s and Motorola 21CT2 sets I take one of those lids cut out a center neck hole paint it black and if theres any metal rings that revit into the cover I pick the remanants of the old cover out of the revit, center the original metal ring on the lid then hit the side of the lid opposite of the revit with a soldering iron to melt the spot over the revit so I can squish it onto the revit...The results are fairly hard to distinguish from factory, and the only tools you need are scissors and a soldering iron.
|