|
My problem here has gradually gotten worse. The large resistor in the high voltage cage isn’t the problem. It tested right on the money. Now I have a raster but no picture at all. I decided to check my voltages in the bleeder box and discovered that I have virtually no negative voltages. All the resistors here measure within specs. I have less than 1 volt on the green wire to the focus coil where there should be 100 volts. Only a few millivolts where there should be -18 volts and -2 volts. No smoke from any of the aluminum electrolytics but I suppose something might have failed here despite having all of them being replaced three or four years ago. It’s all very puzzling and I’m not sure where to start. This set has an RCA 8TS30 chassis. Any suggestions are greatly appreciated! Thanks!
|