|
So, new development.
Now the red projector has gone out of alignment. Creating a red wave across the screen.
Before I made this post I read some stuff online which lead me to believe the convergence board was going.
My question is, is the red being out of alignment related to the jitter?
I see one cap on one of the main boards that is swollen. At this point I'm not sure which board is which. Just digging in.
I do see caps on the boards connected to the projectors. I don't know anything about the terminology relating to this stuff. but, should I mess with the smaller boards on connected to the red projector or should I just stick to the board where I already see the swollen cap?
|