|
I decided I'm going to install all the new pots I have for the board. I found another pot that causes the screen to shimmy as I'm adjusting it, and it also continues to shimmy intermittently afterwards until I wiggle the shaft. Figure it can't hurt to use the NOS pots I have.
I've also decided to remove the chassis, put it on the bench and replace all the electrolytics I put in 13 years ago. While I'm in there I'm also going to check all resistors. I know I won't see the true value being in circuit, but I can see if it's way out of spec or worse. I'm also going to remove the tuner again as it gets stuck at times switching channels and I have to go up and down the channels again to get it where I want. Figure something just needs cleaning/lubing.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|