Ok, here is my update, The flyback has been changed out with no big issues. Seemed pretty easy, lot of sodering though. There is two before and after pics down below. I am in the process of changing a few caps. There was 2 that were leaky and another had fell apart at my figertips as I looked to see what the value would be. The chassis has since then got a good bath, all clean now
. Replaced a few wires under the chassis. While im waiting for the caps to come in I've been checking resistors. So that brings me to my new little problem, The sevice mode switch had come apart at some point in time so I pieced it back together and resodered it back into place to the board. Seems fine, cleaned the inside contacts, switches back and forth, but when I checked R6 on the board I get a reading of 6.8ohms when the switch is in normal mode, when switched to service mode it is a dead short across R6, is that correct, I think the resistor should be like an 8K but i can't really tell what the first band is. Sams does not list this as R6 so I've got myself all confused here
.