|
|
|
#1
11-27-2005, 07:07 PM
|
||||
|
||||
|
Andrea Schematic Needed
I have been recapping my Andrea CVL16. A ton of caps in this beast, more electrolytics than I recall in any tv. Once I was halfway through I cranked it up & had a raster so I finished the job. It was humming along but I noticed a wisp of smoke. I tilted it on it's side & tried again but it was hard to localize. Finally a big burst of smoke (steam, maybe more appropriate) came out of one of the new electrolytics. All the while the set kept playing, which is encouraging. Well, looks like I'm going to need a schematic to figure out whats wrong. Likely a mistake on my part. This is 1/2 of a 30-30 can & I recall being mixed up about the ground wires but thought I had it right. Hopefully somebody can help? Once I get the bugs out it should make a nice set. Needs a tuner, too, which hopefully I'm on the trail of.
BTW, Sams # 125-3.
__________________
Bryan 
|
|
#2
11-27-2005, 11:15 PM
|
||||
|
||||
|
I have it. Send me a PM with mailing info and I'll send it to you.
__________________
The world's worst TV restoration site on the entire intranoot and damn proud of it. http://evilfurnaceman.tripod.com/tvsite
|
 |
|
|
Linear Mode
