|
tried yet another 3a3, this time no blue glow at all. while I was at it I swapped a newer looking 6BK4 shunt (clear glass not as brown), HV went up so I adj back to about 24kv, holds steady from full to no brightness settings so I think its about done. I just need to bring it inside so I can watch it for a while and monitor the flyback heat. I would like to add a thermistor to the set even if I dont have the auto degausser setup just to save some stress on the switch. The CL90's that I have been using are only rated at 2 amps but there is a 3 amp one listed on mouser.
Last edited by DaveWM; 11-16-2012 at 01:28 PM.
|
11-16-2012, 01:21 PM
Threaded Mode