sylvania sylouette

[Glenz75]

Congrats Looking good, must be satisfying to seeing a stable picture on it, CRT looks healthy too!

[ggregg]

I think I'm going to have to pull the sweep/ps chassis again. Something is pulling down the HV a little. Can't quite fill the screen, worse on right than left. Pin cushions seem fine. Swapped out the 1B3, Damper, 12DA6, and anything else related to horizontal, no change. Width control is a slug and works somewhat but even at max range doesn't fill the edge.

[DavGoodlin]

Do you need a schematic?
I have the factory one issued through Electronic Technician Magazine "circuit digest" which shows a rather simple horiz sweep ciruit with voltages and waveforms.
I assume yours is model 21C529 or similar with 1-541 chassis.

[ggregg]

I've got one, just haven't dived into it that far yet. Basically just a complete recap at this point. Thanks though.

[ggregg]

Played with the pincushion magnet on the one side and am able to pretty much eliminate the problem but the other side adjusts much easier. Can the magnet be a little weak on the one side? It was adjusted further in even before I adjusted it more. Have a little teeny tiny bit of a curve on the right side but was able to get it almost straight and still keep the picture full. Played for three hours and it's still fine.