|
If you look at the “alignment instructions” in the sams, it says to connect a variable bias supply to point A, this will override any voltage present and allow you to set your own due the the high resistance of the the source.
Using a potentiometer and a 9v as described, should allow you to set the test point from 0 to 9v, which should be enough to see if AGC is the fault.
__________________
=^-^=
Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte.
いとおしい人のために
|