|
|
|
|
|
#1
10-24-2022, 08:13 PM
|
||||
|
||||
|
If you look at the “alignment instructions” in the sams, it says to connect a variable bias supply to point A, this will override any voltage present and allow you to set your own due the the high resistance of the the source.
Using a potentiometer and a 9v as described, should allow you to set the test point from 0 to 9v, which should be enough to see if AGC is the fault.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために 
|
 |
|
|
Hybrid Mode
