|
RCA roundie test jig
looks like it has very low time on it just from general cleaness of it. No markings on the CRT but I think its a non bonded (has saftey glass front plate, too dirtry to be sure but could not see a cat.
will check the CRT later. Even if bad, I will at least get a convergence assy/yoke/14pin connector.
The cabinet is in very nice shape, hammertone grey. I may put my CTC-16 in it if the CRT is bad, the CTC-16 I have is in a eaten up (termite) cabinet that is to far gone to fix. That would give me a nice metal chassis table top.
|
05-02-2011, 02:13 PM
Threaded Mode