a real challange?

[Yamamaya42]

Originally Posted by Kevin Kuehn

That is a shield because the signal level is so low at the detection point. You really should not need to disturb much under there.

I took these hand held photos of what Riders has on the model 895. You can compare the audio section to your Sams. I did not study it in depth, but it appears basically the same minus your set is not using the 1st audio or output tubes. It's curious that your chassis actually has the 6AT6 1st audio tube installed, but it's not being used.

If you want to keep these Riders pages you'd better save them because I can't promise how long they will be posted on my Flickr page.

https://www.flickr.com/photos/152661...57713086856613

THANKS!

That does help quite a bit!
I was pulling my hair out and screaming trying to figure it out...
SAMS left some things out :O
like the green wire that runs back to the tuner, not sure what it does, or why it was left out, but IT CAN BE SEEN on all SAMS versions, ( photos ) , just not on the schematic, it is however on what you uploaded !

and yes I did remove that plate, I have to get under it to remove the wire and add the normal sound circuits, will put it back after.

thanks again that makes this easier!