|
|
|
#11
03-28-2020, 06:17 PM
|
||||
|
||||
|
1 meg resistor replaced.
flyback put back in. https://imgur.com/NV9COl1 taken with no CRT hooked up. YES, adjusting the drive control has slight effect on HV, by about 1.5 volt. At this point, I'm not sure if I believe what the DVM told me or not, as the HV is now normal. and the sweep looked OK,I did look briefly for a "Fly 1 " but did not get any hits, if it is really bad I'd have to look harder, but I'm not sure where  EDIT-- just hooked up a CRT and the HV went up to 11kv. i am really doubting the FBT is bad now...
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために Last edited by Yamamaya42; 03-28-2020 at 06:33 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode