Philco 41-285 wiring issue

[Mick AV-8]

Looked at it again.
The cut pin on the tube has the electrolytic wire and resistor going to it..it looks fried..and that is the pin that was cut.
The other wire and resistor goes from the same source to the pin above.
I put white dots on the pin/sockets..that have no wire going to them.
So maybe with the help of y'all..you can tell me the correct way it was suppose to be wired..I have another tube with no pins cut..and I could give it a go...
Bulbs lite up..but no sound or sign of life when plugged in...this tube was cold when plugged in.
Not sure why such a cludge was done.
any help or suggestions..is so much appreciated!
I would never get these things going without the help of others..thanks again.
Hope you can comment.

Mick