Quote:
Originally Posted by Kevin Kuehn
I finally got my CTC-11 chassis hooked up to my CK3000 jig. The CRT in my unit has some major convergence issues. I can get the center ok, but there's no control over the outer edges. Maybe this is normal for these?
I'm also having a problem with vertical height. I can't get the jig to match the height of the CRT in my set. I assume that would be controlled with the yoke-programming plug?
My 11 has a lot of smearing on text. Probably needs alignment, but I'm not ready to go there. 
The poor thing still has all it's original caps in it.
Kevin |
It is normal for the edges of the jig not to be in convergence.
03-11-2011, 04:26 AM
Threaded Mode