Scored a Philco 41-316RX !

[bandersen]

Hi. Good question - I almost damaged one of the bars figuring it out.
First off, there is a wood screw driven into each bar from below. I laid the cabinet on it's back to get those out.
The tricky part was discovering the small wood screw driven in at a 45 degree angle behind the top of each bar.
With both screws removed. it was possible to push each bar up about an into into the cabinet which freed up the bottom. Then, tilt the bar at an angle and pull it out.
I do have some video, but might upload it for a while - I'm busy with other projects at the moment.

Please post a link to yours when you get a chance.
Thanks, Bob.

I still have a bit more work to do on the cabinet, but it's coming along nicely.