|
|
|
#11
09-09-2013, 09:38 PM
|
||||
|
||||
|
I dug out the new CRT tonight, I had to unbolt a cabinet and swing it out of the way to get the tube out, it's been trapped in there for quite a few years.
It's a Channel Master with a date stamp of 1984 I think, can't make out the last digit too well but I think that's what it was. Good news, it still checks like new, as it should, also the area of the safety glass that is cracked has delaminated, I could probably pull that piece off if I wanted to. It wasn't like that last time I saw it, probably at least 5-8 years ago, also it smells like deteriorating plastic so the PVA is probably going bad. I put it in the second bathroom, I don't use that one so it won't be in the way, it has a shallow shower only tub, about 4 inches deep, or just right to soak the tube in for a while. I added a little Clorox to keep it from getting rank and maybe it'll help break down the PVA, I also scraped off the clear tape they used to contain the PVA to allow the water to get to it. I noticed some fine bubbles around the edge so I hope it's water seeping into the PVA. This will work out great since it's going in a set that didn't use a bonded tube, the screen color may be a bit different though. 
|
|
|
Threaded Mode