Admiral 20B1 Combo restoration

[SwizzyMan]

Well the sync section which is half of the vertical osc 6sn7 and the 6au6 sync sep have had all of the resistors and capacitors replaced in the circuit. Only thing that might be an issue is that I burned a .1 cap too much with my soldering iron and I think that cap may be bad. But that cap goes from a pin on the vertical output tube to the damper and that cap doesnt seem to have much to do with any vertical or sync circuitry. Should I replace that cap? all of the tubes are new ones that I replaced the old bad ones with so I am not sure where to go from here!