Quote:
Originally Posted by bandersen
I'd go after the horizontal centering first. The 100uF electrolytic cap across it might be bad or installed backward. If so, it would likely be the source of the zipper interference too.
|
I had a few minutes to spare last night so I looked at the horizontal centering. I tried putting a 100uf cap across the control to see if it made a difference and it did nothing. The pot reads at 10ohms and smooth from end to end. There is ~ +385VDC or so on the input, wiper, and output of the control. I'm not quite sure where to look next.
01-20-2017, 12:13 PM
Threaded Mode