Quote:
Originally Posted by vortalexfan
The only problem I have with the 3D printing of the channel indicator escutcheon is that I wonder if the plastic would hold up to a hammer nails because the original escutcheon was attached with 4 small brass nails one on each corner and I would hate for the hammer to slip while trying to attach the escutcheon to the cabinet and shatter the escutcheon.
Other than that I like the idea of printing off an escutcheon, as for the knobs, someone here has already offered me some originals for a small cost.
|
Familiar with what a 'nail set' is?...it is a small steel rod with a point on one end finish carpenters that make cabinets and or install molding in homes use it to drive nails flush with the wood without making hammer marks.
11-06-2019, 08:43 AM
Threaded Mode