|
|
|
#10
04-20-2020, 07:26 PM
|
||||
|
||||
|
https://imgur.com/y84aCsd
OK.. I can't get a stable reading of any resistance between pin 1-2 , it's jumping all over the place, prob from going through all the coils, nor can i get a stable reading of resistance to the point "red wire" but there is 68v on both plates, ( sams says 50v) between pins 5-6 was 438 ohms, ( additive of the 2 150 ohm resistors ), voltage at those pins changed dramatically with picture (contrast ) control.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために 
|
| Audiokarma |
|
|
Threaded Mode