|
|
|
#11
09-19-2022, 02:54 PM
|
||||
|
||||
|
Running raw w/o tubes is not recommended, UNLESS you limit input voltage with a variac.
Reason is, the power supply is non regulated, and dependent on load, the tubes in the set ARE that load, w/o the tubes in the set, the voltage generated can exceed the ratings of the filter electrolytic capacitors and damage them (internal shorts), when you run w/o tubes one must be very careful not to let the bias voltage spike above the rate the capacitors can tolerate, or it can be really bad.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために 
|
|
|
Threaded Mode