![]() |
|
#25
|
|||
|
|||
|
Quote:
Also this chip appears to use a 1.2V reference, which there are very few PWM chips that do. What cuts a lot of the market is the fact that they are using this in locked-frequency sync mode which again very few available chips can do. the SG3525 was attractive to do this, but it requires a modified feedback network due to the differences in reference voltage, and the other problem I ran into is its a push-pull design. I tried to sum the output using gates but it did not work well with the glitching and phase compensation issues. I assume they phase-lock the 22011 power supply section for noise reasons, but they also pick off the R/C timing circuit ramp that runs off to the horizontal deflection stage to an extra winding on the yoke. idk if its a pincushion/horizontal parabola circuit or what. So i put it aside for now, I did find a couple different ICs i can tinker with which have single-ended outputs and can phase-lock. I attached the insanity that ensued haha. The picture is hard to see because the forum software is still expecting attachments stuck in 1992. Last edited by mbates14; 09-17-2023 at 08:08 AM. |
| Audiokarma |
|
|