|
|
|
#6
04-15-2025, 11:38 PM
|
||||
|
||||
|
If it's a Dumont RA-103 doghouse then it's parallel heater.
On a parallel heater set you can run the CRT heater through a voltage doubler circuit (couple of 220uF 25V caps and a pair of 1N400x diodes) which will make around 12.6VDC from 6.3VAC (CRT heater shouldn't care if it's being fed DC) then you can use a LM317 or LM337 (and a pair of resistors to set its output voltage) to regulate that anywhere from 1.37V up to 12.6V...You can even use a pot to adjust the level on the fly.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
|
|
Threaded Mode