|
Ok I'll check the heater voltage on the crt next time I power it up for a test, then jump it and see if any difference. Hmm maybe I'll try heating the resistor up on the bench and make sure it goes to a few ohms first. This set was a bit odd to me to begin with as they had installed a filament booster, but the crt tests just as good on my tester as my other 21' pic tubes. Possible the filaments were all too low with this busted resistor. But in the end I'll probably find the booster was needed somewhat anyway for legit reason(s)...Frenchy
|
08-04-2005, 06:10 PM
Threaded Mode