CTC-10 adjustment lug?

[frenchy]

I know I'm using the correct + and - connections on the adapter, and it is DC... attached is a scan of the schmatics for the remote chassis and the clicker...also here's a pic of the gear in the remote control mech I fixed. Glued the halves together with thin film of superglue, and now it should last forever with JBWeld and two washers to make it solid and take the place of the stress ring that normally goes on the stem. I might put little bead of JB along the other side's rim but can't put in in center as that's where the lock ring goes. I need this gear in there just to be able to change the channels since this set even changes the channel electrically from the console via a bar, not a channel knob.