Emerson 662 restoration

[Eric H]

I'm going to rebuild this set for my next project.
It has a rejuvenated CRT but it's holding well into the good range so I think it'll be OK.

My first question is about the knobs.
It was missing most of them, I thought they were similar to the 637 knobs but the cover of the Sams shows large round knobs with the numbers on them.
The cabinet however has a number plate attached to it which wouldn't make sense if the numbers are on the knob.

Either someone added the plate later (looks factory) or Emerson used two different styles during production.

Here are some pictures, the knob shown is from a different model Emerson and matches up with the Sams picture pretty well, the wear pattern around the upper hole would be consistent with a larger knob but I'm not sure about the channel selector.

Does anyone have one of these with a set of knobs they could photograph?